The Raptor Rim Blast Pro is a professional automatic rim shot blaster designed for uniformly dulling and preparing the surface of steel and aluminum rims before repainting. The machine is primarily designed for processing rims from which the old paint has been previously removed, for example, using chemical methods. Its primary purpose is not to strip the paint, but to create a clean, uniform, and properly developed surface, providing good conditions for applying new paint coats. The automatic process reduces time-consuming, manual rim sanding. The rotating rim is evenly exposed to the abrasive, ensuring a repeatable and controlled treatment. A uniform surface ready for painting. After stripping, discoloration, tarnish, oxidation, and areas of varying degrees of roughness may remain on the rim. The Raptor Rim Blast Pro evens the surface, removes light contaminants, and creates a uniform profile for further refinishing steps. A rim prepared this way can be sent for priming, powder coating, spray painting, or further finishing. Proper surface preparation helps improve the adhesion of the new coating and reduce the risk of problems resulting from imprecise manual sanding. Automatic operation and repeatable results. The machine is equipped with two blasting turbines that direct the abrasive material onto the rotating rim. Automatic rotation allows for even processing of subsequent sections of the surface without the need for continuous manual control of the nozzle. A typical preparation cycle for a previously depainted rim takes approximately 4 minutes, depending on its condition, the abrasive used, and the machine settings. The Raptor Rim Blast Pro supports rims ranging from 13 to 24 inches, allowing it to work with both typical passenger car rims and larger rims. The abrasive material operates in a closed circuit and is reused in subsequent cycles. An integrated separation system separates dust and fine contaminants from the working material, which can then be reused. The chamber is protected by a rubber lining that reduces wear on its walls and dampens abrasive impact. Dust is collected in pull-out drawers, which facilitates regular cleaning. Efficient dust filtration: The filter unit removes dust-laden air from the work chamber. Automatic pneumatic filter cleaning helps maintain dust extraction efficiency and reduces the need for frequent cleaning of the cartridge. Key features: Designed for mattifying wheels after repainting, surface preparation prior to painting, supports 13- to 24-inch rims, two blasting turbines, automatic rim rotation, typical processing time of approximately 4 minutes, uniform and repeatable results, closed abrasive circulation, integrated separation and filtration system, automatic pneumatic filter cleaning, rubber-lined work chamber, drawers for easy dust removal, robust design for professional use, Polish production and service by Raptor Tech. Who is the machine intended for? The Raptor Rim Blast Pro is primarily suitable for: wheel refinishing plants, powder coating shops, automotive repair shops, wheel restoration companies, and metal surface preparation plants. The system weighs 1100 kg. It can be expanded with a work basket for blasting smaller details like turbines and car calipers. Raptor Rim Blast Pro shortens the rim preparation phase, reduces manual work, and produces a smooth surface ready for recoating.